In addition to metal panel systems and the trim associated with those systems, MDM also supplies roofing contractors with the various sheet metal flashings that are required with all types of roof systems, fabricated to the project’s specifications:
Quality and consistency are assured through the use of computer controlled brake forming equipment that has very high dimensional and angle bending repeatability. Computer programing makes it possible to fabricate complex shapes, such as the custom cornice shown below. Our 100+ years of fabrication & installation history assures you that we have some good ideas on the proper design of flashings that a job may require. There are often multiple ways to design a certain flashing and the performance difference can be dramatic.
Current building codes require that perimeter metal (edgings, gravel stop, and coping) be tested according to an ES-1 procedure. We have a selection of ES-1 compliant perimeter metal edgings.
Our fabrication capabilities go beyond the typical brake formed trim.